EN/RSD
Log in
Good morning

UV/LED Lamp For Curing GALAXY700 48W with Low Heat Function

  • Code: 23581

UV/LED Lamp For Curing GALAXY700 48W with Low Heat Function

  • Code: 23581

GALAXY700 professional lamp for curing UV and LED/UV products.
Due to simultaneous double light source of 365nm (nanometer) and 405nm (nanometer), it is perfect for fast curing of:

  • UV and LED/UV builder gels
  • UV and LED/UV colour gels
  • UV and LED/UV gel polishes
  • UV and LED/UV top coats (matte or glossy)

FEATURES:

  • 27 LED diodes
  • Maximum lamp power: 48W
  • Input operation mode: AC 100-240V, 50/60Hz, 1A
  • Output operation mode: DC 24V 1.5A
  • Dimensions: 200 mm x 170 mm x 100 mm
  • Timer: 30s / 60s / 90s 
  • Low heath mode: 120s
  • Sensor time: 90s
  • Changeable bottom 

CONTENTS OF THE BOX:

  • GALAXY700 UV/LED lamp
  • DC 24V adapter
  • Protective transport components
  • User manual
  • Changeable bottom 
  • Three rubber front cover in different colors (pink, purple and white)

Connect the adapter to the device and connect the adapter to the adequate power supply.

Immediately after connecting the device to an electric circuit a sensor becomes active, activating the diodes under the lamp once a hand is placed underneath, operating for 120 seconds. Once the hand is removed from the area, the light emission stops.

Apart from the above mentioned mode, depending on the required length of gel or permanent polish curing, the lamp can have 4 other different modes:

  • 10 seconds operation mode
  • 30 seconds operation mode
  • 60 seconds operation mode
  • The “Low heat mode” 

10, 30 and 60 seconds operation modes are activated by pressing the designated mode activation button, marked with a corresponding label (10s, 30s or 60s). Once the chosen mode has been selected, the diodes will start emitting light. After the selected time expires, the diodes will stop emitting light.

  • The “Low Heat Mode”

The “Low Heat Mode” is activated by shortly pressing the 90s button. This mode cures gels or permanent polishes for a total of 90 seconds, divided into three continuous phases:
* Phase one taking place with 1/3 of the total lamp power, lasting for 30 seconds.
* Phase two taking place with 2/3 of the total lamp power, lasting from the 30th to the 45th second.
* Phase three curing taking place with the lamp on full power. This phase starts from the 45th second, lasting until the 90th, after which the diodes stop emitting light. 


Each mode can be interupted by pressing its activating button.

Before the first use, it is necessary to remove the protective film from the reflecting surfaces.

Top